Description
IMU Rev.B is based on the ICM20608 or ICM20602 sensor. I2C IMU Rev.A based on MPU-6050 is not recommended for new designs.
Specifications
Dimensions 18×20 mm
Distance between the mounting holes 14.2 mm
Diameter of the mounting holes 3 mm
Features
Built-in IMU sensor, can be used as a second frame sensor or as a main sensor.
Possibility to regulate voltage from 6 up to 11 V and connect small motors despite current of a battery.
Has the same sockets as the full size SimpleBGC 32-bit.
Possibility to connect optional Bluetooth module.
The ICM-20608-G is the latest 6-axis device offered by TDK Invensense for the mass market. Compared to previous 6-axis devices, the ICM-20608 offers lower power consumption, lower noise, and a thinner package. The ICM-20608 offers a duty-cycled operation mode for the gyroscope, that reduces gyroscope power consumption by half or more (depending on ODR) compared to earlier 6-axis devices. It also provides about 20% lower noise than previous devices, and about 17% thinner package compared to previous devices. The ICM-20608 is a 6-axis MotionTracking device that combines a 3-axis gyroscope, and a 3-axis accelerometer in a small, 3 mm x 3 mm x0.75 mm (16-pin LGA) package. It also features a 512-byte FIFO that can lower the traffic on the serial bus interface, and reduce power consumption by allowing the system processor to burst read sensor data, entering into a low-power mode.
Manufacturer:Electronic Components
Datasheet:Others/Tiny_Simple_Connections_eng.pdf
