Description
Linear Technology LT1016CS8 High Speed Comparator Analog Comparator, Single, Precision, 1, 10 ns, 4.6V to 5.4V, -2V to -7V, SOIC, 8 Pins SMD SOIC-8 IC, PRECISION COMP, SINGLE, 10NS, SOIC-8, Comparator Type:Precision, No. of Comparators:1, Response Time:10ns, Supply Voltage Range:4.6V to 5.4V, -2V to -7V, Comparator Case Style:SOIC, No. of Pins:8, IC Output Type:CMOS, TTL
Number of Elements 1
Output Type CMOS, Complementary, TTL
Voltage – Supply, Single/Dual (±) –
Voltage – Input Offset (Max) 3mV @ ±5V
Current – Input Bias (Max) 10µA @ ±5V
Current – Output (Typ) 20mA
Current – Quiescent (Max) 35mA
CMRR, PSRR (Typ) 96dB CMRR, 75dB PSRR
Propagation Delay (Max) 14ns
Hysteresis –
Operating Temperature 0°C ~ 70°C
Package / Case 8-SOIC (0.154″, 3.90mm Width)
Mounting Type Surface Mount
Supplier Device Package 8-SOIC
- UltraFast™ (10ns typical)
- Operates off single +5V supply or ±5V
- Complementary output to TTL
- Low offset voltage
- No minimum input slew rate requirement
- No power supply current spiking
- Output latch capability
Applications
Description
The LT®1016 is an UltraFast 10ns comparator that interfaces directly to TTL/CMOS logic while operating off either ±5V or single 5V supplies. Tight offset voltage specifications and high gain allow the LT1016 to be used in precision applications. Matched complementary outputs further extend the versatility of this comparator.
A unique output stage provides active drive in both directions for maximum speed into TTL/CMOS logic or passive loads, yet does not exhibit the large current spikes found in conventional output stages. This allows the LT1016 to remain stable with the outputs in the active region which, greatly reduces the problem of output “glitching” when the input signal is slow moving or is low level.
The LT1016 has a LATCH pin which will retain input data at the outputs, when held high. Quiescent negative power supply current is only 3mA. This allows the negative supply pin to be driven from virtually any supply voltage with a simple resistive divider. Device performance is not affected by variations in negative supply voltage.
Linear Technology offers a wide range of comparators in addition to the LT1016 that address different applications. See the Related Parts section on the back page of the data sheet.
Applications
- High Speed A to D Converters
- High Speed Sampling Circuits
- Line Receiver
- Extended Range V to F Converters
- Fast Pulse Height/Width Discriminators
- Zero-Crossing Detectors
- Current Sense for Switching Regulators
- High Speed Triggers
- Crystal Oscillators
Features
- UltraFast™ (10ns typ)
- Operates Off Single +5V Supply, or ±5V
- Complementary Output to TTL
- Low Offset Voltage
- No Minimum Input Slew Rate Requirement
- No Power Supply Current Spiking
- Output Latch Capability
Manufacturer:Linear Technology
Datasheet:1016fc.pdf
